3 Wheeler Steering
The rack and pinion was acquired early on in the project, since it was needed to confirm the design of the frame. The steering column was also removed from the Ford Sierra. A universal joint was purchased to attach to the end of the spline on the rack and pinion. This joint was then connected to the steering column. A steering wheel was acquired from a scrap yard. A new mounting plate was manufactured for the back of the steering wheel. A nylon bush was made to support the steering wheel and act as a bearing, as shown below. All three drivers sat in the seat, in its different position and an optimum steering wheel position and angle was determined. A frame was welded onto the main chassis to support the steering column.
